HiPath 3000 - Operating Instructions - DTMF Telephones/Pulse Telephones

Answering Calls from the Entrance Telephone and Opening the Door

If an entrance telephone has been programmed, you can use your telephone to speak to someone at the entrance telephone and to activate a door opener.
If you are authorized to activate a door opener (contact System Support), visitors can open the door themselves by entering a 5-digit code (using a DTMF transmitter or installed keypad).

Step by Step

Speaking to visitors via the entrance telephone:

Precondition: Your telephone rings.

Lift the handset within thirty seconds. You are connected to the entrance telephone immediately.

Lift the handset after more than thirty seconds.

Dial the entrance telephone number.

Opening the door from your telephone during a call from the entrance telephone:

( )

Enter the code.

Dial the entrance telephone number.


	Special features must be taken into consideration if your telephone operates with HiPath AllServe (system networking via PC network) !

Opening the door with a code (at the door):

After ringing the bell, enter the five-digit code (using the keypad or a DTMF transmitter). Depending on how the door opener has been programmed, a doorbell call signal may or may not be forwarded.

Activating the door opener:

Lift the handset.

Enter the code.

Dial the entrance telephone number.

Enter the five-digit code. Default code = "00000" (contact System Support).

Enter the type of door opener. 1 = enable with ring, 2 = enable w/o ring = You can also open the door without a doorbell ring.

Deactivating the door opener:

Lift the handset.

Enter the code.

Dial the entrance telephone number.


	HiPath 3000 - Operating Instructions - DTMF Telephones/Pulse Telephones	P31003-H1012-C102-3-7619	Conversion Date: 2001-11-28

	DTMF Telephones/Pulse Telephones


			© Siemens AG 2001