Starting System Administration

Before you begin, you must start system administration. Once system administration has been started, the main menus and functions appear on the screen and can be modified. For details on the individual functions contained in the main menus, refer to the main menu or submenu table . This table is followed by an explanation of the various functions (note page references).

Step by Step

Press the specified key. The LED lights up

Select and confirm.

Enter the code.

Enter user name
(Default ="*95"; can be changed by your service technician).

Confirm your entry.

Enter password
.(necessary only if you or your service technician defined a password).

If you are starting system administration for the first time, do not enter a password. Just press to accept the "US:Identification UK:Ident/Password" prompt. You do not have to do this if your service technician has already set up a password for you.

While the system will prompt you to enter a password (up to 16 characters long), you can ignore the request.
In either case, press to confirm.
Once you have entered your password, you need to enter it again.

Make a note of your password because even your service technician cannot recover it later on.

Confirm your entry even if you did not enter a password.

System administration is now active and the available functions (main menu) appear on the screen.


	You can also carry out the system administration functions during a call. Once you have started system administration, no further access to system administration is possible.

Exiting System Administration

You can exit system administration at any time; any unconfirmed entries or changes are discarded.

Step by Step
	Press the specified key. The LED goes out.


	HiPath 3000 - Operating Instructions - Assistant TC	P31003-H1012-C107-3-7619	Conversion Date: 2001-11-28

	Assistant TC


			© Siemens AG 2001