Speaking to visitors via the entrance telephone:

Precondition: Your telephone rings. 

Lift the handset within thirty seconds. You are connected to the entrance telephone immediately. 

Lift the handset after more than thirty seconds. 

Dial the entrance telephone number. 

Opening the door from your telephone during a call from the entrance telephone:

Press the key. LED flashes. Enter the code. 

Dial the entrance telephone number. 

Special features must be taken into consideration if your telephone operates with HiPath AllServe (system networking via PC network) !

Opening the door with a code (at the door): 

After ringing the bell, enter the five-digit code (using the keypad or a DTMF transmitter). Depending on how the door opener has been programmed, a doorbell call signal may or may not be forwarded. 

Activating the door opener:

Lift the handset.  

Enter the code.  

Dial the entrance telephone number. 

Enter the five-digit code. Default code = "00000" (contact System Support). 

Enter the type of door opener. 1 = enable with ring, 2 = enable w/o ring = You can also open the door without a doorbell ring. 

Deactivating the door opener:

Lift the handset. 

Enter the code. 

Dial the entrance telephone number.